Clicking when turning .
Compare repeated drive-related clicks with steering-joint knocks or strut movement. Avoid hard full-lock acceleration tests.
This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.
Let’s follow the clues.
A few observations help separate the possibilities. Start with safety, then explore the symptoms you already know.
At your pace · no tools required
Understand the possibilities
Driveshaft or CV joint condition
+
Wear or damage in a driveline joint may create load-related vibration, clunks or turning clicks.
A change with applied torque or turning differs from tire vibration at a steady road speed. Do not provoke the sound with hard turns.
After confirmation
Professionally inspect joints, boots, shafts and mountings, then repair the confirmed source.
Steering linkage or joint condition
+
Worn, loose or binding steering joints can cause play, knocking or inconsistent steering effort.
Steering movement before wheel response, knocks during turning or instability need a mechanical inspection.
After confirmation
Have linkage, joints, rack mountings and wheel suspension inspected; do not attempt to adjust out safety-critical play yourself.
Shock absorber or strut damping
+
Reduced damping can allow repeated body motion and irregular tire contact. Springs, mounts and tire condition must also be checked.
Repeated bouncing, fluid leakage on a damper or cupped tread supports suspension inspection; a simple bounce observation cannot grade a shock.
After confirmation
Professionally inspect dampers, springs, mounts and tires and replace confirmed faulty parts according to axle requirements.
Urgent signs
Is control difficult, is the car suddenly unstable, or is a wheel or tire visibly damaged?
Stop driving as soon as you can safely do so. Switch the vehicle off and obtain professional roadside assistance. Do not restart to investigate.
Checks you can make safely
When safely parked, check cold tire pressures against the vehicle placard and inspect visible tread and sidewalls without going under the car.
Leave these to a professional
Do not reach into a running engine bay, work under an unsupported vehicle, bypass safety systems or open fuel, high-voltage or refrigerant circuits.
When to get help
Arrange professional inspection. Share the conditions, warning messages and your answers; ask the workshop to confirm the cause before repair.
This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.
A little more clarity
Can this confirm the failed part? +
This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.
Technical references
Sources explain general principles. Exact procedures and equipment depend on your vehicle. Editorial synthesis; no independent mechanic sign-off claimed.
Follow a related clue
Vibration under load
Torque-dependent vibration differs from vibration caused mainly by road speed. Compare driveline joints, mounts and engine running.
Front suspension knocking
Front-end knocks can travel through the chassis. Distinguish bump movement from turning, braking and steering play before naming a joint.
Steering rack knocking
A sound near the rack is not enough to condemn it. Inner joints, mounts and nearby suspension transmit similar knocks.