# Starter does not crank

No rotation, clicks or a single clunk? Compare available electrical power with start authorization before blaming the starter.

> This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.

## What you may notice
- Engine remains stationary during a start request
- Cabin electrical equipment may still operate

## Understand the possibilities
### Discharged or weakened 12 V battery
A weak 12 V supply may cause slow cranking on combustion vehicles, dim lights or failure to reach READY on an EV or hybrid. Voltage alone does not establish battery health.

**What distinguishes it**
Slow cranking and light dimming support this path more than normal-speed cranking.

**Safe observation**
With the vehicle off, look for obvious case damage or corrosion without touching terminals. Do not disconnect the battery with the engine running.

**After confirmation**
Test battery state, charging and connections; charge or replace only as appropriate for the vehicle.

### Starter, connection or start authorization
Normal cabin power with no crank may involve the start circuit, interlock, key recognition or starter.

**What distinguishes it**
A key warning or a single click helps separate authorization from low available current; neither confirms a component.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Check start authorization, voltage drops and starter current using model-specific service procedures.

### Engine-speed signal or electrical supply
An intermittent sensor, connector or supply fault may prevent engine management from recognizing a running or cranking engine.

**What distinguishes it**
A heat-related cutout followed by restarting after cooling warrants recording live engine-speed and electrical signals.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Verify sensor waveform and wiring under the relevant conditions before replacing a sensor.

## Checks you can make safely
- Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

## Leave these to a professional
- Do not reach into a running engine bay, work under an unsupported vehicle, bypass safety systems or open fuel, high-voltage or refrigerant circuits.

## Urgent signs
- Is there a running-engine oil-pressure warning, overheating/steam, a fuel leak, smoke/burning, severe new knocking, or a flashing engine lamp with strong shaking?

Stop driving as soon as you can safely do so. Switch the vehicle off and obtain professional roadside assistance. Do not restart to investigate.

## When to get help
Arrange professional inspection. Share the conditions, warning messages and your answers; ask the workshop to confirm the cause before repair.

## Technical references
Sources explain general principles. Exact procedures and equipment depend on your vehicle. Editorial synthesis; no independent mechanic sign-off claimed.
- [HELLA: Checking the starter](https://www.hella.com/techworld/en/technical/car-electronics-and-electrics/starting-and-charging-system/checking-the-starter/)
- [DENSO: Alternator troubleshooting](https://www.denso-am.eu/news/alternator-troubleshooting)
- [US Federal Trade Commission: Auto repair basics](https://consumer.ftc.gov/articles/0211-auto-repair-basics)

## A little more clarity
### Can this confirm the failed part?
This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.
