# Cooling fan not running

A stationary fan is not always a fault. If temperature rises, stop safely and have fan demand, electrical supply and sensing checked.

> This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.

## What you may notice
- No fan movement when operation was expected
- Temperature may have risen in slow traffic

## Understand the possibilities
### Cooling fan power or control
Fan behavior depends on temperature, A/C demand and control strategy. A sensor or circuit fault can leave it on or prevent operation.

**What distinguishes it**
Running after shutdown can be normal on some vehicles; failure must be assessed against temperature and commanded operation.

**Safe observation**
Only look at the reservoir level when the engine is fully cold and the manual permits it. Never open a hot pressurized cooling system; electric fans may start unexpectedly.

**After confirmation**
A workshop checks command, power, fuses and motor operation while keeping clear of automatic fan movement.

### Temperature sensor or indication
An incorrect temperature signal can affect the gauge, fan strategy and engine-management behavior.

**What distinguishes it**
A display inconsistent with a cold start or available diagnostic readings warrants a plausibility and circuit check.

**Safe observation**
Only look at the reservoir level when the engine is fully cold and the manual permits it. Never open a hot pressurized cooling system; electric fans may start unexpectedly.

**After confirmation**
Compare actual temperature, live values, wiring and sensor behavior using the model procedure.

### Fan demand or normal after-run
A/C demand and thermal after-run can operate a fan without an engine fault. The permitted behavior is model-specific.

**What distinguishes it**
A brief after-run or a fan operating with A/C differs from continuous operation after every fully cold start.

**Safe observation**
Only look at the reservoir level when the engine is fully cold and the manual permits it. Never open a hot pressurized cooling system; electric fans may start unexpectedly.

**After confirmation**
Compare behavior with the manual and actual command/temperature data; repair only a confirmed control or motor fault.

## Checks you can make safely
- Only look at the reservoir level when the engine is fully cold and the manual permits it. Never open a hot pressurized cooling system; electric fans may start unexpectedly.

## Leave these to a professional
- Do not reach into a running engine bay, work under an unsupported vehicle, bypass safety systems or open fuel, high-voltage or refrigerant circuits.

## Urgent signs
- Is there overheating, steam, rapid coolant loss or an oil-pressure warning while the engine runs?

Stop driving as soon as you can safely do so. Switch the vehicle off and obtain professional roadside assistance. Do not restart to investigate.

## When to get help
Arrange professional inspection. Share the conditions, warning messages and your answers; ask the workshop to confirm the cause before repair.

## Technical references
Sources explain general principles. Exact procedures and equipment depend on your vehicle. Editorial synthesis; no independent mechanic sign-off claimed.
- [HELLA: Cooling system check and diagnostics](https://www.hella.com/techworld/in/technical/car-cooling-system/cooling-system-check/)
- [DENSO: Seven steps of a complete A/C service — bulletin 05-AC-2025-EU](https://assets.denso-am.eu/production/attachments/DENSO-AC-Compressor-7-steps-Bulletin-EN.pdf)

## A little more clarity
### Can this confirm the failed part?
This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.
