# Power windows not working

Compare one window with all windows and motor sound with glass movement. Keep fingers clear and never defeat anti-pinch protection.

> This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.

## What you may notice
- Glass does not move or moves unevenly
- May affect one door or every window

## Understand the possibilities
### Window regulator or mechanical guide
A regulator or guide fault may prevent glass movement even if the motor can be heard. Jammed glass must not be forced.

**What distinguishes it**
Motor sound with stationary, tilted or dropped glass points to mechanical inspection rather than assuming a dead switch.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Professionally secure the glass and inspect regulator, guides and motor without defeating anti-pinch protection.

### Wiring, connector or control-module signal
An intermittent connection or module signal can interrupt a function even when the mechanical component is intact.

**What distinguishes it**
Intermittency, several affected functions or onset after repair support circuit checks before a component is condemned.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Use vehicle-specific diagrams, fault data and supply/ground tests to confirm the affected circuit.

### Discharged or weakened 12 V battery
A weak 12 V supply may cause slow cranking on combustion vehicles, dim lights or failure to reach READY on an EV or hybrid. Voltage alone does not establish battery health.

**What distinguishes it**
Slow cranking and light dimming support this path more than normal-speed cranking.

**Safe observation**
With the vehicle off, look for obvious case damage or corrosion without touching terminals. Do not disconnect the battery with the engine running.

**After confirmation**
Test battery state, charging and connections; charge or replace only as appropriate for the vehicle.

## Checks you can make safely
- With the vehicle off, look for obvious case damage or corrosion without touching terminals. Do not disconnect the battery with the engine running.

## Leave these to a professional
- Do not reach into a running engine bay, work under an unsupported vehicle, bypass safety systems or open fuel, high-voltage or refrigerant circuits.

## Urgent signs
- Is there smoke, a burning smell, a hot or damaged battery, or exposed wiring?

Stop driving as soon as you can safely do so. Switch the vehicle off and obtain professional roadside assistance. Do not restart to investigate.

## When to get help
Arrange professional inspection. Share the conditions, warning messages and your answers; ask the workshop to confirm the cause before repair.

## Technical references
Sources explain general principles. Exact procedures and equipment depend on your vehicle. Editorial synthesis; no independent mechanic sign-off claimed.
- [ELTA Automotive: Window lift regulators — common questions](https://eltaeurope.com/elta-automotive-resources/aftermarket_insights/window-lift-regulators-the-questions-were-asked-most/)
- [HELLA: Central locking system: function and troubleshooting](https://www.hella.com/techworld/in/technical/sensors-and-actuators/zentralverriegelung/)
- [HELLA: Air-mass sensor — function and troubleshooting](https://www.hella.com/techworld/en/technical/sensors-and-actuators/check-air-mass-sensor/)
- [HELLA: Checking the starter](https://www.hella.com/techworld/en/technical/car-electronics-and-electrics/starting-and-charging-system/checking-the-starter/)
- [DENSO: Alternator troubleshooting](https://www.denso-am.eu/news/alternator-troubleshooting)

## A little more clarity
### Can this confirm the failed part?
This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.
