# Excessive fuel consumption

First compare similar journeys and measurement methods, then consider rolling resistance, engine temperature and mixture control.

> This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.

## What you may notice
- Fuel use has risen compared with similar trips
- Frequent short trips or altered running may be present

## Understand the possibilities
### Operating conditions or rolling resistance
Short cold trips, changed loads and incorrect tire pressures can change measured fuel use without identifying an engine fault.

**What distinguishes it**
Compare like-for-like trips and the same measurement method; a display reset can change the apparent average.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Correct tire pressures and investigate drag or abnormal temperature with a workshop if the increase persists.

### Air metering, throttle or EGR control
Incorrect air measurement or actuator operation may disturb idle, response and emissions. A code alone is not a failed-part verdict.

**What distinguishes it**
Rough idle, hesitation and an engine lamp support comparing actual and commanded readings and checking for intake leaks.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Verify air-path sealing, power supplies and live sensor/actuator data before cleaning or replacing components.

### Combustion misfire
Shaking with a flashing engine lamp can accompany active misfire. Petrol ignition, injection and compression require different tests.

**What distinguishes it**
Rough running separates this from an isolated steady lamp; a fault code identifies a test direction, not automatically a failed part.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Read stored codes and freeze-frame data, then verify the affected combustion system before repair.

## Checks you can make safely
- Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

## Leave these to a professional
- Do not reach into a running engine bay, work under an unsupported vehicle, bypass safety systems or open fuel, high-voltage or refrigerant circuits.

## Urgent signs
- Is there a running-engine oil-pressure warning, overheating/steam, a fuel leak, smoke/burning, severe new knocking, or a flashing engine lamp with strong shaking?

Stop driving as soon as you can safely do so. Switch the vehicle off and obtain professional roadside assistance. Do not restart to investigate.

## When to get help
Arrange professional inspection. Share the conditions, warning messages and your answers; ask the workshop to confirm the cause before repair.

## Technical references
Sources explain general principles. Exact procedures and equipment depend on your vehicle. Editorial synthesis; no independent mechanic sign-off claimed.
- [NHTSA: Tire safety — TireWise](https://www.nhtsa.gov/vehicle-safety/tires)
- [US Federal Trade Commission: Auto repair basics](https://consumer.ftc.gov/articles/0211-auto-repair-basics)
- [HELLA: Air-mass sensor — function and troubleshooting](https://www.hella.com/techworld/en/technical/sensors-and-actuators/check-air-mass-sensor/)
- [HELLA: Exhaust gas recirculation](https://www.hella.com/techworld/en/technical/car-electronics-and-electrics/exhaust-gas-recirculation/)
- [HELLA: Throttle potentiometer](https://www.hella.com/techworld/en/technical/sensors-and-actuators/throttle-potentiometer/)
- [NGK: Spark plug questions and answers — fouling](https://ngksparkplugs.com/wp-content/uploads/2020/10/QA-SparkPlug-.pdf)

## A little more clarity
### Can this confirm the failed part?
This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.
