# Engine stalls at idle

A stall when stopped differs from a cutout at road speed. Compare idle stability, added loads and whether the engine restarts.

> This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.

## What you may notice
- Engine stops while stationary or as revs fall
- Idle may dip before the stall

## Understand the possibilities
### Air metering, throttle or EGR control
Incorrect air measurement or actuator operation may disturb idle, response and emissions. A code alone is not a failed-part verdict.

**What distinguishes it**
Rough idle, hesitation and an engine lamp support comparing actual and commanded readings and checking for intake leaks.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Verify air-path sealing, power supplies and live sensor/actuator data before cleaning or replacing components.

### Intake air leak
Air escaping or entering a joint can whistle; on petrol engines unmetered intake air may disturb idle.

**What distinguishes it**
An airy hiss with rough idle differs from a sharp belt squeal. A workshop leak test is needed.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Repair the verified hose, joint or ventilation fault, then check mixture and fault data.

### Restricted or intermittent fuel delivery
Fuel supply faults can cause extended cranking, hesitation or a stall; pump sound alone cannot establish pressure or flow.

**What distinguishes it**
Load-related hesitation or a refueling/low-fuel association adds evidence, but testing must distinguish pump, filter and electrical supply.

**Safe observation**
Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

**After confirmation**
Professionally measure fuel delivery and supply-circuit behavior without opening pressurized lines as a driver check.

## Checks you can make safely
- Park safely, switch the vehicle fully off and consult its owner manual before any visual observation. Keep clear of moving or hot components.

## Leave these to a professional
- Do not reach into a running engine bay, work under an unsupported vehicle, bypass safety systems or open fuel, high-voltage or refrigerant circuits.

## Urgent signs
- Is there a running-engine oil-pressure warning, overheating/steam, a fuel leak, smoke/burning, severe new knocking, or a flashing engine lamp with strong shaking?

Stop driving as soon as you can safely do so. Switch the vehicle off and obtain professional roadside assistance. Do not restart to investigate.

## When to get help
Arrange professional inspection. Share the conditions, warning messages and your answers; ask the workshop to confirm the cause before repair.

## Technical references
Sources explain general principles. Exact procedures and equipment depend on your vehicle. Editorial synthesis; no independent mechanic sign-off claimed.
- [HELLA: Air-mass sensor — function and troubleshooting](https://www.hella.com/techworld/en/technical/sensors-and-actuators/check-air-mass-sensor/)
- [HELLA: Exhaust gas recirculation](https://www.hella.com/techworld/en/technical/car-electronics-and-electrics/exhaust-gas-recirculation/)
- [HELLA: Throttle potentiometer](https://www.hella.com/techworld/en/technical/sensors-and-actuators/throttle-potentiometer/)
- [Garrett Motion: Turbo diagnostics](https://www.garrettmotion.com/ja/turbo-replacement/turbo-diagnostics/)
- [US Federal Trade Commission: Auto repair basics](https://consumer.ftc.gov/articles/0211-auto-repair-basics)
- [Delphi: Testing a fuel pump with scope testing](https://www.delphiautoparts.com/en-gb/mom/need-to-know/article/testing-a-fuel-pump-with-scope-testing)

## A little more clarity
### Can this confirm the failed part?
This is symptom guidance, not a confirmed diagnosis. Inspection and vehicle-specific tests are needed before replacing parts.
